Eaton LINX, Руководство по установке

Страница: 86 / 123

C o r n e r L a m i n a t e
S h e l f ( c o n t . )
3. Install one Rear Support “A” and one Rear Support
“B” on each side of the Organizer. See Figure 4 .
Ensure that each Rear Support “B” is at the same height
as the Shelf Side Brackets.
NOTE : All Corner Shelves with the exception of the
WD06-XX * are pre-drilled. This shelf is not pre-drilled
to allow installation of the 12”/18” sides on the desired
side of the Organizer.
If you are installing the WD06-XX, position it as desired
on the Brackets/Supports and mark the location of the
two holes in the Side Brackets on the bottom of the
Shelf.
With two people, remove the Shelf and drill four 1/8”
diameter holes 1/2” deep into the bottom surface. Then
with two people, re-position the Shelf onto the Brackets/
Supports.
Fasten the Shelf to the two Side Brackets with four #10
x 3/4” Phillips head screws. See
Figure 5 .
* The WD06-XX Corner Shelf is 42”(1067mm) x 42”
(1067mm) with one 12”(305mm) side and one 18”
(457mm) side.
81571
technical furniture
D-19
Figure 4
6” approximately
Rear support “A”
Rear support “B”
Figure 5
#10 x 3/4” Phillips
head screws
Upper shelf