- 34 -
Once the ring terminals are in place, tighten the hex nuts evenly on both sides.
Note the way the
ring terminals are placed and direction of the wires.
Install a flat washer, insulator, flat washer and Nyloc hex nut on the threaded rod and tighten in
place. The stack up of the hardware will allow the insulator to move slightly. Also seat the wires in
place in the insulators as shown below.
Four views showing the capacity hat assembly with the
upper two insulators and wire/ring terminals installed.
Repeat the assembly steps to install the lower two insulator/wire assemblies.
