Douwe Egberts Cafitesse 100, Руководство по обслуживанию

Страница: 123 / 210

07.2004
5A - 41
Functions - Water System Service Manual Cafitesse 100
General remarks:
• The boiler is filled with water from the tank
via a hose connection at the rear wall of
the dispenser and a special inlet valve.
• Before the dispenser is transported, the water
must always be drained from the boiler.
• The water can be drained from the boiler
from outside by using a special hose.
• The retrofitted dispenser is equipped with a
heating switch at the rear wall.
Installation of the kit 'tank top'
This description is based on the consideration
that the dispenser was connected to the water
supply and ready for operation before.
Preparation:
• Switch off the dispenser and disconnect it
from the mains supply.
• Disconnect the dispenser from the water
supply.
• Loosen the screw (2) and remove the
operating panel cover (1). (Fig. 2)
• Remove the front cover and the advertising
panel (3) towards the side. (Fig. 2)
CAUTION: When the front cover is made of
glass, there is the danger of being
injured due to incorrect handling
or breaking of the glass.
• Remove the cooling compartment lid (4).
(Fig. 2)
• Remove the housing cover (6). (Fig. 2)
• Remove the air duct (7). (Fig. 1)
• Remove the rear wall (5). (Fig. 2)
• Drain the water from the boiler.
• When filling the boiler for the first time, the
heating must be switched off. This prevents the
dry running protection being activated as the
filling process via the tank takes longer than
filling via the standard inlet valve with the
pressure of the water supply line.
• The heating must also be switched off
every time the boiler is to be filled after the
water has been drained completely from the
boiler, e.g. for transport or repair.
xxx
xx
xxx
xx
ST
OP
xxx
xx
4 6
7
5
2
1
3
Fig. 2