Douwe Egberts Cafitesse 100, Руководство по обслуживанию

Страница: 118 / 210

07.2004
5A - 36
Functions - Water System Service Manual Cafitesse 100
• It must be observed that the bridges (1) on
the I
2
C espresso/café cool interface board are
closed. (Fig. 7)
• Connect the I 2 C espresso/café cool interface
board (3) to the control (2) as shown in fig. 8.
• Attach the control to the boiler.
• Make sure that the two foils which are
situated behind the overflow safety thermostat
are placed in front of the control. (Fig. 9)
• Connect the cable harness of the I 2 C
interface (1) to the plug ST10 (2) of the
control (blue) and to the plug ST01 (3) of the
interface board (blue). (Fig. 10)
• When the dispenser is equipped with an older
EPROM version, replace the EPROM on the
control. Required: EPROM version "SAT1
V2.4" or more up to date.
• Unplug the power supply. (see chap. 5K.2)
• Remove the cup carrier.
• Remove the coil of the inlet valve.
• Remove the dummy cap at the right front
side of the pot carrier.
• Insert the wirings of the cold water valve (4)
cable harness S30-NO and S30-C (5) into the
drip tray at the right front side. (Fig. 10)
• Connect the wirings with the white rocker
switch and press the switch into the opening.
• Connect the 6-pole bush BU02 (7) of the cold
water valve (4) cable harness to the plug
ST02 (blue) (6) on the interface board.
(Fig. 10)
• Insert the control and connect the safety
thermostat.
• Insert the plug ST09A (8) of the 24 V I
2
C
interface (10) cable harness into the 2-pole
bush BU09 on the control. (Fig. 10)
Fig. 8
Fig. 9
2
3
Fig. 7
1