851-899 Rev. A
17
Dorner Mfg. Corp.
FlexMove FC (105 mm) Conveyor System
Installation
Slide Rail Installation at Wheel Bend
1.
Infeed Wheel Bend:
Cut the slide rail end
36, item 1)
in flat. Make sure there is a 5 mm gap
created at the plastic molding part. The step is applied
onto outfeed as well.
Figure 36
Figure 36
2.
Outfeed Wheel Bend:
Follow step 1.
Figure 37
Figure 37
3. In the outer bend, make sure that the slide rail is
properly connected to the conveyor beam profile.
Figure 38
Figure 38
Slide Rail Installation at Horizontal
Plain Bends and Vertical Bend
In plain bends with a small radius, the slide rail for the inner
bend should be cut so that it is only 10 mm wide in the bend.
This is to prevent an uneven slide rail surface. Stretch the
slide rail while mounting.
Drilling Slide Rail
1. Drill two holes near the beginning of each slide rail
section. Use the drill fixture
to
ensure clean-cut holes and the correct location of the
holes. The holes must be at the leading edge of the joint
piece, in the direction of travel, to hold the slide rail in
place when the conveyor is in use. Use a well sharpened
4.3mm, #18, or 11/64
"
drill bit.
Figure 39
Figure 39
2. Use a bigger drill bit or countersink bit
40, item 1)
to deburr and countersink the holes. Also
make sure that there are no metal filings left underneath
the slide rail.
Figure 40
Figure 40
1
1
1
1
1