Dorner Mfg. Corp.
12
851-899 Rev. A
FlexMove FC (105 mm) Conveyor System
Installation
Conveyor Installation
Conveyor beams are mounted on to the support structure by
means of support brackets. There are three different types of
conveyor beam support brackets. They all serve the same
purpose but are connected to the structural beams in different
ways.
Option 1
Horizontal beam support brackets (60mm or 80mm)
are used for horizontal support structure
mounted to 64x64mm or 80x80mm support beams.
Figure 14
Figure 14
Option 2
Vertical beam support brackets
are used
with vertical support beams and are made from aluminum.
Figure 15
Figure 15
Option 3
Dual side mounting brackets
are used to
support 180° wheel corners.
Figure 16
Figure 16
Mounting Conveyor Beam Support
Bracket
1. Attach screws, nuts and washers to the support bracket
before mounting. (Screws and
square nuts are support beam fasteners; T-bolts and nuts
are conveyor beam fasteners.) Slide the square nuts of
one support bracket into the support beam T-slots.
Tighten the screws. Make sure that the support bracket
is aligned with the beam cross-section
as shown in the drawing.
Figure 17
Figure 17
1
1
1
1
2