Dodge Ram 2004, Руководство по обслуживанию

Страница: 379 / 642

PCM COMMUNICATION FAILURE (STORED)
When Monitored: With the ignition on.
Set Condition: This DTC will set if the A/C - Heater Control Module does not receive the
message from the PCM for more than 5 seconds. This message provides Engine RPM and
Vehicle Speed.
RECIRC OVERCURRENT (STORED)
When Monitored: When actuator movement is requested.
Set Condition: This DTC will set if the A/C - Heater Control Module detects an excessive
current draw on any of the door driver circuits while attempting to drive this actuator.
Only one overcurrent DTC can set per ignition cycle.
RECIRC SWITCH FAULT (STORED)
When Monitored: With the ignition on.
Set Condition: This DTC will set if the MAX on/off switch stays closed for 10 minutes.
REFRIGERANT PRESS RX FAILURE (STORED)
When Monitored: With the ignition on.
Set Condition: This DTC will set if the A/C - Heater Control Module does not receive the
Refrigerant Pressure message from the PCM for more than 20 seconds.
TX FAILURE (STORED)
When Monitored: When the ignition is on.
Set Condition: This DTC will set if the A/C - Heater Control Module is unable to send a
PCI Bus message.
VIN RX FAILURE (STORED)
When Monitored: With the ignition on.
Set Condition: This DTC will set if the A/C - Heater Control Module does not receive the
VIN message from the PCM for more than 5 seconds.
ZONE OVERCURRENT (STORED)
When Monitored: When actuator movement is requested.
Set Condition: This DTC will set if the A/C - Heater Control Module detects an excessive
current draw on any of the door driver circuits while attempting to drive the Driver Blend
(dual-zone) actuator. Only one overcurrent DTC can set per ignition cycle.
POSSIBLE CAUSES
CHECK FOR ACTIVE HVAC DTCS AND SYSTEM TEST FAULT MESSAGES
STORED CODE(S) TEST COMPLETE
365
HEATING & A/C
A/C SWITCH FAULT (STORED) —
Continued