Direct Healthcare Group QUATTRO Acute, Руководство по обслуживанию

Страница: 54 / 60

Q U AT T R O
®
A C U T E & Q U AT T R O
®
P L U S
D H G - H E A LT H C A R E . C O M 5 3
4.6 EMI/EMC Statement and Manufacturer’s Declaration
This equipment has been tested and found to comply with the limits of EN 60601-1-2.
These limits are designed to provide reasonable protection against harmful interference in both a medical and residential
environment. This equipment generates, uses and can radiate radio frequency energy and, if not used in accordance with
manufacturer’s instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception or other equipment, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment.
• Connect the equipment to an outlet on a circuit different from that to which the receiver or equipment was connected.
The equipment having been tested to operate within the limits of electromagnetic compatibility. (Immunity to interference
from nearby sources radiating radio frequency energy). Sources exceeding these limits may give rise to operation faults.
Where possible the system will sense the interference and if it is of short duration transparently take countermeasures
whilst operating near normally, or failing this will issue a warning and take measures for the continued safely of the
user. Further increased levels of energy may cause the system to stop operating, continuously generate random faults
or continuous resets.
Try to ascertain the source of the interference by turning nearby or suspect equipment off, and see if the interference
effects stop. In any such event the user is encouraged to try to correct the interference by one of the following measures:
• Have the interfering equipment repaired or replaced.
• Reorient or relocate the interfering equipment.
• Increase the separation between the equipment and the possible source of the interference.
• Connect the equipment to an outlet on a circuit different from that to which the interfering equipment was connected.
Information Regarding Electro Magnetic Compatibility (EMC) According to
IEC60601-1-2
With the increased number of electronic devices such as PCs and mobile telephones, medical devices in use may be
susceptible to electromagnetic interference from other devices. The EMC (Electro Magnetic Compatibility) standard
IEC60601-1-2 defines the levels of immunity to these electromagnetic interferences. On the other hand, medical devices
must not interfere with other devices. IEC60601-1-2 also defines the maximum levels of emissions for these medical
devices. The QUATTRO conforms to this IEC60601-1-2 standard for immunity and emission. Nevertheless, special
precautions need to be observed:
• The QUATTRO needs to be installed and put into service according to the EMC information below.
• The QUATTRO is intended for use in the electromagnetic environment specified in the tables below. The user of the
QUATTRO should assure that it is used in such environment.
• In general, although the QUATTRO complies too the EMC standards, it can be affected by portable and mobile RF
communications equipment (such as mobile telephones).
• The QUATTRO should not be used adjacent to or stacked with other equipment. In case adjacent or stacked use is
necessary, the QUATTRO should be observed to verify normal operation.