Direct Healthcare Group QUATTRO Acute, Руководство по обслуживанию

Страница: 30 / 60

Q U AT T R O
®
A C U T E & Q U AT T R O
®
P L U S
D H G - H E A LT H C A R E . C O M 2 9
8. Connect the CCV push and turn interface to the CCV on unit and then
connect the plenum chamber and pressure gauge to the tube
at 60° on the interface. Then attach the flow meter to the plenum
chamber and the pressure gauge to the connector on the pipe to the
flow meter.
9. Pressing and holding the down arrow key to set pump to its
maximum operating level, the unit will display ‘Pump Power: 1700’.
Make sure the valve on the flow meter is fully closed by turning the
black knob fully clockwise.
10. Make sure the valve is closed on the pressure gauge and take the
pressure reading from gauge. This reading should be
no lower than 100mmHg for a Type 19R internal double
pump.
11. Fully open the valve on the flow meter by turning the black
knob fully anti-clockwise and take the reading from the
flow meter. This reading should be no lower than 8 L/P/M
for a Type 19R internal double pump.
A
A
B
B
C
C
HOLD
9
8
10
11
2.12 Mattress Pressure Tests
1. Connect the mattress umbilical to the CCV
assembly on the power unit by inserting and
rotating clockwise until the green dot is fully visible
in the locator aperture. Plug in the mains power
lead and switch the unit on.
2. ‘STARTING PLEASE WAIT !’ is displayed whilst
optical sensor is moving to zero position.
3. ‘INITIALISING PLEASE WAIT !’ is displayed while
mattress is reaching operating pressure.
4. Once initialised the power unit will start to run in default mode Active Medium and the unit will display ‘ACTIVE
MEDIUM’.
1
2 3 4