Digitax M1 mdt, Установка и программирование

Страница: 31 / 84

The information contained here are property of DIGITAX Automotive Electronics Italy, and extremely con fi dential. Any disclosure, copying, distribution to third
party is strictly prohibited.
31
Tari
ff
Show
The procedure to use the Tari
ff
Show is as follows:
1. Keep pressed K2 for few seconds to enter
in the menu selec on
2. Select TAR-SH by pressing K2
3. Con
fi
rm by K4 the Tari
ff
Show viewer
4. To go to the next programmed value press K4
5. To go to the previous programmed value press K3
Every me K4 is pressed you will go to the next pa-
rameter index in the same order as speci
fi
ed before
for each programmed block (up to 6).
When the last parameter index of the last block (t6)
is shown, by pressing K4 again the Tari
ff
Show viewer
will display the Four Extras programmed values (from
F1 to F4):
To exit from Tari
ff
Show menu and go back to For Hire
posi on, press OP .
...
TAR-SH
A T1 60.00
10.21
1200.00 B T1
60.00
A T1
90.0
B1 T1
4000.0
C T1
F1 T0 0.95
F2 T0 0.95
F3 T0 0.95
F4 T0 0.95
Initial Amount ID TAR. NUMBER
Time 1st Unit ID TAR. NUMBER
Initial Amount ID TAR. NUMBER
Distance 1st Unit ID TAR. NUMBER
Distance Other Units ID TAR. NUMBER
Extra Amount ID TAR. NUMBER
Extra Amount ID TAR. NUMBER
Extra Amount ID TAR. NUMBER
Extra Amount ID TAR. NUMBER