Digital Projection LIGHTNING 10sx, Руководство пользователя

Страница: 90 / 151

✍
✍
✍
Configuring a Computer Channel
1. Set Gamma in Image Mode to Preferred Value
2. In the Channel Set-up Menu select Computer Source and Colour Temperature.
3. Apply intended computer input.
4. Select Size & Position.
5. The cursor should be over the correct rate mode, press ENTER.
6. Set Pixels to equal the number of pixels per line in the signal source.
7. Define the aspect ratio as 4 x 3.
8. Adjust the Horizontal and Vertical Size until beating patterns minimise or
disappear (use an alternate pixel pattern from Paintbrush to emphasise errors).
9. Some Horizontal bars may remain, remove them by adjusting the Pixel Phase.
No Vertical Size adjustment should be required for a Raw source.
10. Adjust the Position to centre the image on the DMD™ display.
11. Use Pluge as per the Video channel set-up (previous page) to set up the
Brightness and Contrast.
Computer outputs cannot have negative values and therefore computer pluge bars
are +2% and +4% and should both be visible. An acceptable set-up pattern can be
created using Paintbrush.
Sharp, Hue and Saturation will have no effect on computer sources.
CÑ43
System Operation
OPERATION
LBV00056; Revision A - 23/08/99