Digital Projection LIGHTNING 10sx, Руководство пользователя

Страница: 144 / 151

This guide assumes the projector has been previously installed and configured in
accordance with the System Installation guidelines in this Manual.
Setting Up the Projector
Check that the input source you wish to display is connected to the back of the
projector. If it is not, and you are unsure how to connect the source, refer to System
Installation, B—13.
Connect the projector and the input device to the mains supply and switch on (the
projector's power button is located at the back, on the left hand side). After turning
the projector on, check that air is flowing out of the vent on the top of the projector
case, if it isn't, turn the projector off immediately and contact your dealer.
If after 25 seconds the projector lamp has not lit (and the red LED is illuminated on
the front of the projector), switch off the projector and turn it back on again.
When the projector starts up, it will display images using the settings defined by the
'At Power Up' section of the User Preferences - you may need to select new settings.
On Screen Display
The On Screen Display (OSD) displays the menu system and messages and unless
pre-set to OFF in the User Preferences, will appear when the projector starts up.
The OSD must be turned ON if you wish to make changes to the projector set-up. If
it is OFF, it can be activated using the OSD ON button on the remote control.
When OSD is ON, the menu system can be temporarily removed by pressing
MENU on the remote control. To re-activate the menu system, press MENU again
and you will be returned to the last menu screen used.
i
Appendix
Quick Set-up Reference
APPENDIX
LBV00056; Revision A - 23/08/99