Digital Projection LIGHTNING 10sx, Руководство пользователя

Страница: 102 / 151

The Palm Pilot Control Utility has been designed to allow extensive operational
control of the projector without using the on-screen menu system.
The Palm Pilot connects to the projectors computer port via a straight wired 9 pin
male to female cable and uses the following settings - 19,200 baud, 8 bits, no parity,
1 stop bit, no flow control.
Assuming the connection to the projector is set up correctly, when you activate the
Power Control Utility the Function screen will be displayed. This screen allows
selection between control of DV Series or GV Series projectors or to use the Lens
and Lumen Calculation functions.
Upon selection of a projector, the utility will establish a connection with the
projector and the Main Screen will appear providing the main controls - Chan,
Lamp, PMute, Addr, Quit, Query, Pic adj and Geo Adj.
Chan - allows you to directly select a projector channel. To select channels one
through nine the corresponding button should be used. To select channels 10 and
above, first press 10+ then the sequence for the required channel. The current
channel (or the status of the channel change) will be displayed above the channel
selection buttons.
Lamp - sets the lamp power to high, low or off. The current setting will be
displayed above the lamp power buttons.
PMute - sets the picture muting. The current setting will be displayed.
Addr - allows you to define the projector address you want to control when using
multiple projectors.
It is only possible to query one projector at a time with the Palm Pilot program and
the addresses of the individual projectors must be pre-defined before they can be
controlled. If you define an address of 0 with multiple projectors connected, your
return values will be invalid.
CÑ55
System Operation
Palm Pilot Control Utility Operation
OPERATION
LBV00056; Revision A - 23/08/99