Digital Projection LIGHTNING 10sx, Руководство пользователя

Страница: 62 / 151

SELECT Command
Channel selection can be made in two ways, by simply keying in the channel
number on the remote control or by selection in the Channel Set-up screen. Using
the remote control is quicker if you know the channel number required, but if you
don't, the Channel Set-up screen will remind you.
To select a channel using the On Screen Display, first choose Channel Set-up
from the the Main Menu and locate the cursor over the desired channel using the
ñ
and
ò
buttons. Highlight 'SELECT' from the options at the bottom of the screen
using the
ï
and
ð
buttons and press 'Enter' to display the selected channel.
If a blank channel is selected, the image display will turn black and a message box
will be overlaid stating- "Channel XX not configured"
If a valid channel is selected but a source is not detected at the input, the screen will
go black until the signal is connected. A message box will be overlaid stating-
"Source is not Present".
If a valid channel is selected but the detected source is different from that expected,
a message box will be overlaid stating- "Source is not the expected configuration".
The system will do its best to display the image using the parameters of the
selected channel.
If a channel configured for a computer is selected and the projector does not
identify a computer card mode which matches the incoming signal, the screen will
display an image using the system default parameters. These parameters, such as
size and position, are stored in the system memory. An on-screen message also
appears stating- "New mode will be lost if not saved or if channel is changed". The
display will then have to be adjusted manually to give an optimum image (Refer to
Storing System Configurations, B—15 for further details).
CÑ15
System Operation
OPERATION
LBV00056; Revision A - 23/08/99
✍