Digital Equipment LGplus Series, Руководство по установке

Страница: 157 / 194

6–13
Table 6–1. LCD Message Troubleshooting Table (continued)
Displayed
Message
Operator
Can
Correct? Explanation
Solution
COIL HOT
*
No One or more hammer
coils are overheating. Contact your Digital Customer
Service Engineer.
1
CTL VOLT FAIL*
No Controller voltage
failure. Contact your Digital Customer
Service Engineer.
1
DRVR CIR BAD*
No Hammer coil count test
failed. Contact your Digital Customer
Service Engineer.
1
ENERGY STAR
N/A Status message: printer
is in low–energy idle
state, all fans and higher
voltages are off, only
+5Vdc logic circuits are
active. No action required.
EXHAUST FAN FLT
Yes Sensors cannot detect
current in fan circuit. Power off the printer and remove
the paper path. Check that the fan
cable connector is connected.
Check for obstruction of vents
and fan airway, and remove any
obstructions. Check for items
beneath the printer blocking
cabinet vents. Power back on the
printer. If this message recurs,
contact your Digital Customer
Service Engineer.
1
FRAMING ERROR
Yes Serial framing error.
(Serial interface.) Check your serial host interface
parameter settings; if necessary,
adjust them so that they match
the settings of the attached host.
1
Before contacting a Digital Customer Service Engineer, power off the printer, wait 15 seconds, then power
it back on and rerun your print job. If the message reappears, press CLEAR then ONLINE. If the fault
message still displays, then contact the Customer Service Engineer.
continued next page