Digiop D3D-2500, Руководство пользователя

Страница: 63 / 124

55 DIGIOP® 3D Camera User Manual
SECTION 5: CONFIGURE COUNTING LINES
5.11.4 Filtering Tracks based on Velocity
Complete the following steps to exclude tracks that are traveling faster than a certain speed:
1. Access the Counting page.
2. Select the Velocity check box in the upper right corner.
3. Enter a value ( cm/sec) in the Velocity field. A normal walking speed is between 90 – 140 cm/sec.
4. Click Save . The CAMERA will now exclude all tracks that travel through the field of view at a velocity that is higher than the
threshold.
5.12 Enabling Child Counting
Complete the following steps to set count lines to only count tracks that are typically children (those that are below the height filter
set on the Calibration page):
1. Access the Counting page.
2. Right-click the zone name from the zone list. The right-click menu appears.
3. Select
Configure
. The Counting Config Parameters dialog box appears.
4. Select the Enable box in the Child Counting group.
5. Click
OK
. The Counting Config Parameters dialog box closes.
6. Click Save . The changes are saved and the zone is set to only count tracks that are below the Height Filter setting on the
Calibration page.
NOTE
This feature requires purchase of Advanced Firmware. .
5.13 Enabling Shopping Unit Counting
Complete the following steps to enable shopping unit counting: