Configure the device using the Digi ConnectPort X Family web interface
Configuration through the web interface
Digi ConnectPort X Family
118
Use the
Clear list before discovery
check box to clear the discovery list of previously discovered
nodes before performing another discovery operation.
XBee 802.15.4 series products show all nodes as
end nodes
by default. You can set one node in the
network as
coordinator
, as in the following example:
To sort the node list, click any column heading.
To display the configuration settings for the XBee RF module in the ConnectPort X gateway, click a
node's
Network Address
or
Extended Address
. There are several pages of configuration settings:
including basic and advanced settings for the XBee RF module. The settings displayed vary depending
on the XBee RF protocol running in the XBee modules. The settings shown in the following example
are for an XBee ZB module.
