User Manual for DEVO-12
Page 74 of 238
Touch the navigation mark of Status and drop down a menu including Inhibit and
Active. Click Inhibit if you don’t amend the amount of the selected point which is set in
“2.1 Adjustment for Point” (the factory default setting is Inhibit). Click Active if you want
to amend the amount of the said point, and an expansion list including Output and
Hovering is shown below.
2.3) Output adjustment
Touch the left navigation mark of Output to decrease the output amount of the
selected point with a minimum of 0.0%; touch the right navigation mark to increase the
output amount with a maximum of 100.0%.
2.4) Hovering adjustment
After the setting in “2.3 Output adjustment” is finished, it is necessary to set the item of
Hovering as On and all the selected points of the throttle curve should be activated if
using throttle trim in flight is a must. The seven points of 1-3, M, 4-7 in the curve will
being paralleled up or down with the changing of throttle trim. So the throttle curve will
being paralleled up or down with the movements of the seven points.
3) Flight mode
There are total five flight modes: Normal Flight, Stunt 1, Stunt 2, Stunt 3, and Stunt 4,
the curve of which can be respectively set in their corresponding flight mode. The
setting method is same with “2) Curve Setting” above. Regarding the setting for Flight
Mode, please refer to “2.10 Device Select”.
Click the icon
to exit.
3.7 Mix to throttle
This function can keep the main rotor blades running at the certain revolution caused
by the changed load when operating the aileron servo, elevator servo, and rudder
servo. Generally this function is advised to use in aerobatic flight.
Setting method:
Touch the shortcut icon
to enter Function Menu, and then click
to
enter the interface of Mix to Throttle.
If the item of Channel is shown as “Elevator”, there are Channel, Switch, Up, and
Down in the interface. If the item of Channel is Aileron or Rudder, the contents in the
said interface will be changed into Channel, Switch, Left, and Right. Take the example
of Channel set as Elevator to illustrate the setting method.
Содержание DEVO-12
Страница 239: ...G G G G G G G G G G G...