Dell Inspiron 2600, Руководство по обслуживанию

Страница: 34 / 87

Back to Contents Page
EMI Shield, Video Card, and Palm Rest
Dell™ Inspiron™ 2600 and 2650
EMI Shield
Video Card
Palm Rest
EMI Shield
1. Remove the keyboard .
2. Remove the two M2.5 x 5-mm screws that secure the display-feed flex cable to the system board.
3. Pull up on the pull tab that is attached to the display-feed flex cable connector to remove the connector from the system board.
4. Remove the three M2.5 x 12-mm screws that secure the EMI shield to the bottom case, and pull the EMI shield out of the bottom case.
Video Card
Removing the Inspiron 2600 Video Card
1. Remove the keyboard .
2. Remove the EMI shield .
3. Remove the M2.5 x 5-mm screw that secures the video card to the system board.
4. Pull the video card by the edges toward the front of the computer to remove the video card from the bottom case.
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read " Preparing to Work Inside the Computer " before performing the following procedure.
NOTICE: When reconnecting the display-feed flex cable connector to the system board, push down on the top left and right ends of the connector.
Pressing on the center of the connector may damage resistors and compromise EMI protection in the computer.
1 EMI shield
2 M2.5 x 12-mm screws (3)
NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed battery.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: Read " Preparing to Work Inside the Computer " before performing the following procedure.