Dell Brocade DCX, Руководство по настройке

Страница: 541 / 1436

BigIron RX Series Configuration Guide 469
53-1001810-01
Marking
18
Configuring port, MAC, and VLAN-based classification
Assigning QoS priorities to traffic
By default, traffic is forwarded using the best-effort queue (qosp0). However, traffic can be
classified into different priorities, based on the following:
•
Incoming port (sometimes called the ingress port)
•
Port-based VLAN membership
•
Static MAC entry
The following sections describe how to change the priority for each of the items listed above.
Although it is possible for a packet to qualify for an adjusted QoS priority based on more than one of
the criteria above, the system determines the priority it will use for forwarding as described in
“Processing of classified traffic” on page 466.
When you apply a QoS priority to one of the items listed above, you specify a number from 0 – 7.
The priority number specifies the IEEE 802.1p equivalent to one of the four Brocade QoS queues.
The numbers correspond to the queues as follows.
Changing a port’s priority
To change a port’s QoS priority, use one of the following methods. The priority applies to inbound
traffic on the port. The default priority of each port is 0.
To change the QoS priority of port 1/1 on a device to queue 2, enter the following commands.
BigIron RX(config)# interface ethernet 1/1
BigIron RX(config-if-e1000-1/1)# priority 5
Syntax: [no] priority <num>
The <num> parameter can be from 0 – 7 and specifies the priority level equivalent to one of the
four QoS queues.
Changing a Layer 2 port-based VLAN’s priority
By default, VLANs have priority 0. To change a port-based VLAN’s QoS priority, use one of the
following methods. The priority applies to inbound traffic on ports in the VLAN.
To change the QoS priority of port-based VLAN 20 to queue 3, enter the following commands.
BigIron RX(config)# vlan 20
BigIron RX(config-vlan-20)# priority 7
Syntax: [no] priority <num>
Priority level QoS forwarding queue
6, 7 3
4, 5 2
2, 3 1
0, 1 0