Dell Brocade DCX, Руководство по настройке

Страница: 494 / 1436

422 BigIron RX Series Configuration Guide
53-1001810-01
Configuring optional VSRP parameters
15
Displaying ports that have the VSRP fast start feature enabled
The show vsrp vrid command shows the ports on which the VSRP fast start feature is enabled.
The "fast-start ports:" line lists the ports that have the VSRP fast start enabled, and the downtime
for each port.
Changing the backup priority
When you enter the backup command to configure the device as a VSRP Backup for the VRID, you
also can change the backup priority and the track priority:
•
The backup priority is used for election of the Master. The VSRP Backup with the highest
priority value for the VRID is elected as the Master for that VRID. The default priority is 100. If
two or more Backups are tied with the highest priority, the Backup with the highest IP address
becomes the Master for the VRID.
•
The track priority is used with the track port feature. Refer to “VSRP priority calculation” on
page 414 and “Changing the default track priority” on page 425.
To change the backup priority, enter a command such as the following at the configuration level for
the VRID.
BigIron RX(config-vlan-200-vrid-1)# backup priority 75
Syntax: [no] backup [priority <value> ] [track-priority <value> ]
The priority <value> parameter specifies the VRRP priority for this interface and VRID. You can
specify a value from 3 – 254. The default is 100.
For a description of the track-priority <value> parameter, refer to “Changing the default track
priority” on page 425.
Saving the timer values received from the master
The Hello messages sent by a VRID’s master contain the VRID values for the following VSRP timers:
•
Hello interval
BigIron RX(config-vlan-10-vsrp-1)#sh vsrp
VLAN 10
Auth-type no authentication
VRID 1
========
State Administrative-status Advertise-backup Preempt-mode
Link-Redundancy
Backup Enabled Disabled True Disabled
Parameter Configured Current Unit/Formula
Priority 100 100 (100-0)*(4.0/4.0)
Hello-interval 1 1 sec/10
Hold-interval 3 3 sec/10
Initial-ttl 2 2 hops
Master router 219.218.18.52 or MAC xxxx.dbda.1234 expires in 00:00:02
Member ports: ethe 19/1 to 19/2 ethe 19/4 to 19/5
Operational ports: ethe 19/1 to 19/2 ethe 19/4 to 19/5
Forwarding ports: None
fast-start ports: 19/1(10) 19/2(10) 19/4(10) 19/5(1)
Track-port 19/3 priority 50 status up