Dell Brocade DCX, Руководство по настройке

Страница: 272 / 1436

200 BigIron RX Series Configuration Guide
53-1001810-01
Configuring forwarding parameters
7
The first command configured an interface-based static route through Ethernet port 1/1. The
command assigns a metric of 1 to this route, causing the device to always prefer this route when it
is available. If the route becomes unavailable, the device uses an alternate route through the
next-hop gateway 192.168.8.11/24.
Configuring a default network route
The device enables you to specify a candidate default route without the need to specify the next
hop gateway. If the IP route table does not contain an explicit default route (for example, 0.0.0.0/0)
or propagate an explicit default route through routing protocols, the software can use the default
network route as a default route instead.
When the software uses the default network route, it also uses the default network route's next hop
gateway as the gateway of last resort.
This feature is especially useful in environments where network topology changes can make the
next hop gateway unreachable. This feature allows the device to perform default routing even if the
default network route's default gateway changes.
The feature thus differs from standard default routes. When you configure a standard default
route, you also specify the next hop gateway. If a topology change makes the gateway unreachable,
the default route becomes unusable.
For example, if you configure 10.10.10.0/24 as a candidate default network route, if the IP route
table does not contain an explicit default route (0.0.0.0/0), the software uses the default network
route and automatically uses that route's next hop gateway as the default gateway. If a topology
change occurs and as a result the default network route's next hop gateway changes, the software
can still use the default network route.
If you configure more than one default network route, the device uses the following algorithm to
select one of the routes.
1. Use the route with the lowest administrative distance.
2. If the administrative distances are equal:
•
Are the routes from different routing protocols (RIP, OSPF, or BGP4)? If so, use the route
with the lowest IP address.
•
If the routes are from the same routing protocol, use the route with the best metric. The
meaning of “best” metric depends on the routing protocol:
•
RIP – The metric is the number of hops (additional routers) to the destination. The best
route is the route with the fewest hops.
•
OSPF – The metric is the path cost associated with the route. The path cost does not
indicate the number of hops but is instead a numeric value associated with each route.
The best route is the route with the lowest path cost.
•
BGP4 – The metric is the Multi-exit Discriminator (MED) associated with the route. The
MED applies to routes that have multiple paths through the same AS. The best route is the
route with the lowest MED.