Dell Brocade DCX, Руководство по настройке

Страница: 207 / 1436

BigIron RX Series Configuration Guide 135
53-1001810-01
Disabling or re-enabling a port
6
NOTE
Brocade recommends using gig links or 24C’s links for switch uplinks when transmitting Layer 2
Traffic in a bidirectional patterns.
NOTE
To force the port to run at 1000 Mbps, set one of the link’s ports to be the master for the link. To set
a port as a Gigabit master port, enter the following command at the interface configuration level for
the port:
NOTE
Modifying the port speed of a port that has a pre-configured rate limit policy may result in the
inability to remove the port's rate limit policy.
The following example configures the interface to 1000 Mbps, and designate it as the master port.
To force the port to run at 1000 Mbps, set one of the link’s ports to be the master for the link. To set
a port as a Gigabit master port, enter the following command at the interface configuration level for
the port.
BigIron RX (config)#interface ethernet 1/5
BigIron RX (config-if-e10000-1/5)#speed-duplex 1000-master
The following example configures the interface to 1000 Mbps, and designate it as the slave port.
BigIron RX (config)#interface ethernet 2/4
BigIron RX (config-if-e10000-2/4)#speed-duplex 1000-slave
Syntax: [no] speed-duplex {auto |1000-master |1000-slave |1000-full | 100-full | 100-half |
10-full | 10-half}
auto - Autonegotiation
1000-master - Forces 1000 Mbps master port
1000-slave - Forces 1000 Mbps slave port
1000-full - Forces 1000 Mbps full-duplex operation
1000-half - Forces 100 Mbps half-duplex operation
100-full - Forces 100 Mbps full-duplex operation
100-half - Forces 100 Mbps half-duplex operation
10-full - Forces 10 Mbps full-duplex operation
10-half - Forces 10 Mbps half-duplex operation
Disabling or re-enabling a port
The port can be made inactive (disable) or active (enable) by selecting the appropriate status
option. The default value for a port is enabled.
To disable port 8 on module 1 of a device, enter the following.
BigIron RX (config)# interface e 1/8
BigIron RX (config-if-e10000-1/8)# disable
Syntax: disable