Procedure
1
Log on to the Cisco MDS switch.
2
To enter configuration mode, type:
switch-A#
config terminal
3
To specify the interface, type:
switch-A(config)#
interface fc interface_id
4
To disable the interface, type:
switch-A(config-if)#
shutdown
Moving licenses between FC interfaces
Move licenses between FC interfaces on Cisco MDS switches.
About this task
IPv4 addresses are supported on Vblock Systems and VxBlock Systems. IPv6 addresses are supported
on VxBlock Systems.
Before you begin
•
Verify that the Cisco MDS switch is up and reachable through the console or management
connection.
•
Obtain the FC interfaces IDs.
•
Obtain Cisco MDS switch IPv4/IPv6 address/console information, log on credentials and access
method (SSH/TELNET).
Procedure
1
Log on to the Cisco MDS switch.
2
To view the port licenses, type:
show port-license
3
To start the configuration, type:
Switch-A#
config terminal
4
To configure the interface where license is being moved from, type:
Switch-A(config)#
interface fcinterface_id
5
To disable the license on that interface, type:
Switch-A(config-if)#
no port-license
6
To exit, type:
Switch-A(config-if)#
exit
7
To configure the interface where the license is being moved to, type:
Switch-A(config)#
interface fcinterface_id
8
To acquire the license on that interface, type:
Switch-A(config-if)#
port-license
acquire
9
To end the configuration, type:
Switch-A(config-if)#
end
10
To verify that appropriate ports have enabled licenses, type:
show port-license
61
|
Managing Cisco MDS switches
Содержание Vblock Systems 350
Страница 1: ...Dell EMC VxBlock and Vblock Systems 350 Administration Guide Document revision 1 8 October 2017 ...
Страница 114: ...Related information VMware vSphere Networking guide Managing VMware VDS 114 ...
Страница 122: ...Related information Cisco Nexus 1000V Troubleshooting Guide Managing the Cisco Nexus 1000V Series Switch 122 ...
Страница 156: ...4 On the Schedule tab schedule the task to run daily at 1 00 AM Backing up Cisco MDS switches 156 ...
