f
Under
On this switch
, select the VMKernel port by selecting the VMKernel adapter and click
Assign port group
.
g
If you need to delete VMKernel ports, under the VMKernel adapter list, select the VMKernel
port and click
Remove
.
h
Select the port group that belongs to a different vSwitch and click
OK
.
i
Validate the VMKernel port destination and click
Next
.
j
Verify that a
No impact
message appears and click
Next
.
k
Review the summary results and click
Finish
.
Using Disjoint Layer 2 configuration on VMware VDS
Configure Disjoint Layer 2 on VMware VDS. Disjoint Layer 2 is not mandatory for VMware VDS.
About this task
Assign the following to the VMware VDS:
•
Cisco UCS vNIC 4 (10 GB or more depending on VIC hardware)
•
Cisco UCS vNIC 5 (10 GB or more depending on VIC hardware)
A separate VMware VDS is created with two dedicated uplinks to isolate Disjoint Layer 2 traffic from all
other primary VDS traffic. There must be a single VMware VDS created for each data center, but not for
each cluster.
Creating a VMware VDS for Disjoint Layer 2 configuration
Create a VMware VDS for Disjoint Layer 2 configuration.
About this task
On full-width blades with additional network physical ports to the onboard mLOM ports, add vNICs 4 and
5 to the service profile. This must be done individually between reboots, after installing VMware vSphere
ESXi with vNIC 0-3. This is required because of the way VMware vSphere ESXi interprets the Cisco PCI
bus enumeration of the vNICs during installation. VMware does not support remapping the vNICs after
the hypervisor is installed beginning with VMware vSphere 5.5 without a support ticket.
Procedure
1
From the VMware vSphere Web Client
Home
tab, under
Inventories
, select
Networking
.
2
Right-click
Datacenter01
(Logical Configuration Survey (LCS) default name) and select
New
Distributed Switch
.
The disjoint layer 2 Cisco DVswitch naming scheme is as follows:
DVswitch<Converged System ID>-DJL2
Managing VMware VDS
|
108
Содержание Vblock Systems 350
Страница 1: ...Dell EMC VxBlock and Vblock Systems 350 Administration Guide Document revision 1 8 October 2017 ...
Страница 114: ...Related information VMware vSphere Networking guide Managing VMware VDS 114 ...
Страница 122: ...Related information Cisco Nexus 1000V Troubleshooting Guide Managing the Cisco Nexus 1000V Series Switch 122 ...
Страница 156: ...4 On the Schedule tab schedule the task to run daily at 1 00 AM Backing up Cisco MDS switches 156 ...