Dell EMC Vblock Systems 350, Руководство администратора

Страница: 109 / 181

3 From the New Distributed Switch wizard, perform the following:
a Change the name of the distributed switch to DVswitch01-DJL2 unless a different cluster
name is used in the LCS.
b Validate that the cluster location is Cluster01 .
c Click Next .
d Select the appropriate Distributed switch .
e Click Next .
f From the Edit Settings window, change Number of uplinks to
2
.
g Leave Network I/O Control enabled.
h Uncheck Default port group
i Click Next to view the Ready to complete window.
j Review the settings and click Finish if everything is correct. Otherwise, click Back to edit
changes.
4 Repeat this procedure to create a new VMware VDS for each additional workload type.
What to do next
Creating distributed port groups for Disjoint Layer 2 configuration (see page 109)
Creating distributed port groups for Disjoint Layer 2
Create distributed port groups for Disjoint Layer 2.
About this task
Change the load balancing policy from Route based on originating virtual port to Route based on
physical NIC load for all the VMKernel distributed port groups. Disjoint Layer 2 traffic is commonly virtual
distributed port groups only so it would typically be configured with the default settings.
If vcesys_esx_vmotion is configured as Disjoint Layer 2, configure teaming and failover with VMNIC4 in
active state and VMNIC5 in standby state.
Procedure
1 From the VMware vSphere Web Client Home tab, under Inventories , select Networking .
2 Right-click DVswitch01-DJL2 (LCS default name) and select New Distribution Port Group .
3 From the New Distributed Port Group wizard, perform the following:
a Change the name of the distributed port group as provided in the Logical Configuration
Survey (LCS).
b Click Next to configure port group settings.
109 | Managing VMware VDS