LS10 Installation and Operating Guide
Version 1.01
Appendix D. LS10 Remote Controller
D-1
Document #: 9301H66300 Ver. 1.01
Appendix D. LS10 Remote Controller and IR Codes
This appendix describes the controls on the IR Remote Controller provided with the LS10 and
also provides a list of IR codes.
LS10 Remote Control
(1) Custom commands for the Preset buttons, PRESETS 1,2, and 3, are defined in the LS10 GUI by
creating Automation Macros PRESET1, PRESET2, and PRESET3, respectively. For information on
creating Macros in the LS10 see 3.19 Automation Macros.
PRESETS
Use to select
custom preset
commands
(1)
ANALOG
Press button until desired
selection is active:
Stereo 1 or Stereo 2.
DIGITAL
Press button until desired selection is
active: TosLink 1, TosLink 2
SPDIF 1, SPDIF 2, or USB.
VOLUME DOWN
Press and hold to
lower volume level
Pressing once will
change level 0.5db.
NONE
No decoding or
processing applied.
AURO
Auro processing applied.
*Note: If Auro option is not
installed this button is disabled.
PRO LOGIC
Dolby Pro Logic
processing applied.
NEO X
Neo X processing applied.
RED LED
Illuminates when any
button is pressed.
POWER
Pressing once will turn LS10 on or
off depending on current state.
The Remote Controller requires two (2) AAA batteries.
To install batteries:
1. Remove battery compartment cover located on back of remote.
2. Insert batteries correctly by matching the (+) and (-) as shown in compartment.
3. Reinstall battery cover.
HDMI IN
HDMI input
selections 1 – 8.
MUTE
Press to mute or un-mute
all output channels.
VOLUME UP
Press and hold to raise
volume level. Pressing once
will change level 0.5db.
