LS10 Installation and Operating Guide
Page 35
LS10 Installation & Operating Guide
Document # 9301H66300 Ver. 1.01
2.4 Power Supply
WARNING:
Before powering on the LS10 for the first time, verify that the correct input voltage
has been selected at the rear panel power entry module. Incorrect input voltage setting will
damage the LS10.
The LS10 may be set for either 115V (105-130V operation) or 230V (215-260V operation).
Figure 22. Power Entry Module – Voltage Input Settings
2.4.1 Changing the Input Voltage Setting and Fuses
Caution:
Double pole / neutral fusing.
1. Remove the power cord (if plugged in).
2. Open the fuse compartment door.
Use a small flat blade screwdriver to release the door. Protect the LS10 metal finish from damage
by the screwdriver, using a rag or other soft item.
Figure 23. Power Entry Module – Releasing the Fuse Compartment Door
3. Remove the fuse block by freeing it with a small flat blade screwdriver.
The block has slots for this purpose in the sides, as shown. Do not try to pry the block out from the
top or bottom, as this will damage the block. Use a rag or other soft item to protect the LS10 metal
finish.
115V
230V
Screwdriver
Soft rag
