LS10 Installation and Operating Guide
Page 53
LS10 Installation & Operating Guide
Document # 9301H66300 Ver. 1.01
3.9.1 Speaker Options Configuration Screen
Any Left/Right paired speakers share the same settings, so the configuration needs to be set only on one
of the two. For example, when the Left Front speaker is configured, the Right Front speaker will use that
configuration. Speaker pairs that share configurations are L/R, Ls/Rs, Lb/Rb, HL/HR, HLs/HRs, and
Lw/Rw.
Each speaker or speaker pair may display a different set of options. The figure below shows Bass
Management Center Speaker Options for a configuration with Subwoofers. Click the icon of the Center
Speaker, in the Bass Management Setup screen, to access this screen.
Figure 39. Center Speaker Configuration
Options differ for other speakers, and the speaker function may change if there are no subwoofers.
Please refer to the tables in this section for options available depending on speaker: with one or two
subwoofers, Table 10; with no subwoofers, Table 11.
HP/LP Filter
This configures the high pass and low pass filters when Small speaker option is selected. The HP and LP
use is illustrated in the screen image. The HP and LP both use the same configuration.
The slope can be set at either 12dB/octave or 24dB/octave. The cutoff frequency can be set between
31Hz and 160Hz.
Note
: If the bass management option for full range to subs is selected, then there is no
low pass filter. All frequencies in the signal are sent to the sub.