LS10 Installation and Operating Guide
Page 20
LS10 Installation & Operating Guide
Document # 9301H66300 Ver. 1.01
Figure 6. Network DHCP Screen
The DHCP screen displays the IP address assigned by the DHCP server after a system reset. The
addresses shown on the screen are the current settings for the Network IP address, Network Mask
address, Gateway address, and addresses for DNS1 and DNS2. The addresses are displayed whether or
not they were set statically by the LS10 or retrieved from the DHCP server.
Note
: If the IP address is not seen in the DHCP mode, it means the unit is not connected
to the network.
Press
Save
to confirm changes to the network configuration. If changes are not saved, the previous
configuration will display after turning power off and on again from the rear power switch. After Saving
and cycling the power from the rear power switch, the changes will display.
Figure 7. Network Static Screen
On the Static screen, enter the static addresses for IP Address, Network mask, Gateway, and DNS. If
DNS1 cannot be accessed, DNS2 will be used, so either one may be selected.
If Static is selected and saved, the LS10 will (upon reset) use the network configuration address entered
for Network IP address, Network Mask address, Gateway address, and DNS.
