LS10 Installation and Operating Guide
Page 16
LS10 Installation & Operating Guide
Document # 9301H66300 Ver. 1.01
Unmute the LS10
Touch the red MUTE button (the speaker icon in the top right
corner). If successful, the button color will no longer be red.
Identify muted mode
When the LS10 is muted, the MUTE button will turn red.
1.2 Front Panel Controls and Indicators
Figure 1: Front Panel Controls and Indicators
The front panel contains the following controls and indicators for operating the LS10.
•
Touch Screen
: Displays system configuration and status and allows configuration changes.
Most selections can be made by touching the screen with your finger or by using a stylus,
and by turning the Volume control.
•
Volume Control
:
Used for volume control and turning power on/off.
1.3 Powering ON the LS10 Processor
Caution:
Before powering on the LS10 for the first time, verify that the correct input voltage
has been selected at the rear panel power entry module. Incorrect input voltage setting will
damage the LS10. See section 2.4.
Turn ON the main power switch on the rear panel. A “hard boot” (cycling the power at the power entry
module on the rear panel) typically takes the system 35 seconds to initialize.
You can turn power on/off by pressing and holding the center of the Volume control on the front panel.
Also see Appendix D, Remote Controller.
While the system is initializing, the following start up screen will appear. As initialization continues, a
progress bar will appear and status messages will show in the lower left hand corner of the screen.
Volume control
and power button
Touch screen
IR window (for
remote control)
Optional rack ears
(left and right)
