Ordering Information
Rittal TS-8 Enclosure
Frame D3 Kit Part No.
Frame D4 Kit Part No.
Frame E2 Part No.
70.9 in [1800 mm]
176F1824
176F1823
Not possible
78.7 in [2000 mm]
176F1826
176F1825
176F1850
86.6 in [2200 mm]
176F0299
Kit Contents
•
Ductwork components
•
Mounting hardware
•
Gasket material
•
Delivered with D3 and D4 frame kits:
•
175R5639 - Mounting templates and top/bottom cut-out for Rittal enclosure.
•
Delivered with E2 frame kits:
•
175R1036 - Mounting templates and top/bottom cut-out for Rittal enclosure.
All fasteners are either:
•
0.39 in [10 mm], M5 Nuts torque to 2.3 Nm (20 in-lbs)
•
T25 Torx screws torque to 2.3 Nm (20 in-lbs)
NOTE!
Please see the
Duct Kit Instruction Manual, 175R5640,
for further information
3.4.2 Outside installation / NEMA 3R kit for Rittal enclosures
This section is for the installation of NEMA 3R kits available for the VLT series drive frames D3, D4 and E2. These kits are designed and tested to be used
with IP00 / chassis versions of these frames in Rittal TS8 NEMA 3R or NEMA 4 enclosures. The NEMA 3R enclosure is a dust-proof, rain-proof, ice resistant
outdoor enclosure. The NEMA 4 enclosure is a dust-proof and watertight enclosure.
The minimum enclosure depth is 19.7 in [500 mm] (23.6 in [600 mm] for E2 frame) and the kit is designed for a 23.6 in [600 mm] (31.5 in [800 mm]
for E2 frame) wide enclosure. Other enclosure widths are possible, however, additional Rittal hardware is required. The maximum depth and width are
as required for the installation.
VLT
®
Automation Drive FC 300
Instruction Manual High Power
3 How to Install
MG.33.U2.22 - VLT
®
is a registered Danfoss trademark
3-29
3
