Danfoss FC322 Series, Инструкция по эксплуатации

Страница: 51 / 186

Please follow these steps to test the motor connection and direction of
rotation. Start with no power to the unit.
Illustration 5.43:
Step 2: Insert one end in terminal 27 using a suitable ter-
minal screwdriver. (Note: For units with Safe Stop function,
the existing jumper between terminal 12 and 37 should not
be removed for the unit to be able to run!)
Illustration 5.44:
Step 3 : Insert the other end in terminal 12 or 13. (Note:
For units with Safe Stop function, the existing jumper be-
tween terminal 12 and 37 should not be removed for the
unit to be able to run!)
Illustration 5.45:
Step 4 : Power-up the unit and press the [Off] button. In
this state the motor should not rotate. Press [Off] to stop
the motor at any time. Note the LED at the [OFF] button
should be lit. If alarms or warnings are flashing, please see
chapter 7 regarding these.
Illustration 5.46:
Step 5 : By pressing the [Hand on] button, the LED above
the button should be lit and the motor may rotate.
Illustration 5.47:
Step 6: The speed of the motor can be seen in the . It can
be adjusted by pushing the up
▲
and down
▼
arrow but-
tons.
Illustration 5.48:
Step 7 : To move the cursor, use the left ◄ and right ► arrow
buttons. This enables changing the speed in larger incre-
ments.
Automation VT Drive FC322
Instruction Manual 5 Electrical Installation
MG.20.U1.22
51
5