Dalsa Everywhereyoulook Xtium2-CL MX4, Руководство пользователя

Страница: 103 / 151

Xtium2-CL MX4 User's Manual Declarations of Conformity • 101
J5: External Signals Connector (Female DH60-27P)
Warning : J1, J2 and J5 have the same signal assignments. Signals are routed to all 3
connectors directly from their internal circuitry. Therefore never connect J1, J2 and/or J5 to
external devices at the same time.
See DH40-27S Cable to Blunt End (OR-YXCC-27BE2M1, Rev B1) and Cable assemblies for
I/O connector J1 for available cables.
J1: Internal I/O Signals Connector (26-pin SHF-113-01-L-D-
RA)
Important : The table below describes the I/O signals available on both J1 and J5.
Use only one of the two I/O connectors — never both!
Table 6: 26-pin SHF-113-01-L-D-RA (J1) and DH60-27P (J5) Connector Signals
Description Pin # Pin # Description
Ground 1 15 General Input 3 (+)
RS-422 Shaft Encoder Phase A (-) 2 16 General Input 4 (+)
TTL/RS-422 Shaft Encoder Phase A (+)
( see note 3 )
3 17 General Input 4 (-)
Ground 4 18 General Input 3 (-)
RS-422 Shaft Encoder Phase B (-) 5 19 Power Output 5 Volts, 100mA max
TTL/RS-422 Shaft Encoder Phase B (+) 6 20 External Trigger Input 2 or
General Input 2 (-)
External Trigger Input 1/General Input 1 (-) 7 21 General Output 3
External Trigger Input 1/General Input 1 (+)
8 22 General Output 4
External Trigger Input 2/General Input 2 (+) 9 23 General Output 5
Ground 10 24 General Output 6
Strobe 1 / General Output 1
( See note 2 )
11 25 General Output 7
Strobe 2 / General Output 2
( See note 2 )
12 26 General Output 8
Ground 13 27 NC
Power Output 12 Volts, 350mA max
( from Aux Power Connector, see J4)
14