8. Use
221
GB
When the receiver is being used normally (user mode) or when it is in test mode, the screen
displays the consultation menu indicating the receiver statuses.
The different receiver statuses are displayed in the following order
1.
Zones with activated alarms,
2.
Tamper alarms,
3.
Fault alarms,
4.
List of events.
If none of the events above are listed, the screen displays a general message indicating its status.
However, when there are events listed, the screen displays these events.
Example 1:
there is no event indicated by the receiver; the message displayed to indicate this
situation depends on the configuration.
USER MODE
The receiver does not use wireless control devices
Module ready
The receiver does have wireless control devices and the system is
armed.
System armed
The receiver has control devices and the system is
disarmed.
System not armed
Example 2:
only one type of event – Active Zones – is indicated.
Nothing happens when the
t
button is pressed. However, if the
OK
button is pressed, the
screen displays the sub-menu with details relating to the activated detectors (see page 224).
One or several receiver zones have triggered an alarm.
Active zones
>
Example 3:
several situations are listed: Active Zones, (highest priority), Faults and List of Events
(lowest priority).
1.
Press the
t
button to continue consulting the other information listed.
One or several receiver zones have triggered an alarm and other information is also
provided
Active zones
>
Others ...
2.
Press the
t
button to continue consulting the other information listed.
Une ou plusieurs anomalies sont présentes dans le système.
Fault
>
Others ...
3.
If the
t
button is pressed again, the screen redisplays the list of information from the top.
La liste contient de nouveaux événements.
Read Events
>
Others ...
8.1 Consultation menu
