197
GB
1.
Unscrew and remove the fixing bracket from the base.
2.
Using the bracket as a drilling template (check the direction of arrows):
- identify and mark 3 points (
A
&
B
) for the fixing holes,
- identify and mark point (
C
) for the hole in which the magnet (
E
) ensuring protection against
removal will be inserted (it should be positioned at the tip of the arrow).
3.
Drill the holes for fixing points
A
,
B
and
C
using a 6 mm Ø drill bit.
4.
Remove the plastic washers (
D
) connected to the bracket and put them to one side.
5.
Screw the bracket to the wall starting with the two upper points.
6.
Insert one of the plastic washers into the lower hole (
B
) before inserting and tightening the
screw.
7.
Tighten the locking screws to fix the receiver to the wall bracket.
8.
Remove and position the grommets (
F
) supplied in the bag of accessories (make sure you
mount them the right way round).
9.
Perform the electrical connections required between the receiver and the product to be
controlled.
10.
Mount and screw the cable clamps (
G
) supplied in the bag of accessories.
To ensure the receiver works properly:
• do not leave too much extra wire inside the box,
• do not thread the wires around the receiver box.
Hole: 6 mm Ø x 25 mm
OK
NO
NO
5
5
Wall fixing bracket
A
B
C
D
F
E
G
2.4 Fixing the receiver in place
