Daikin VAM-FA8VE, Технические данные инструкция

Страница: 61 / 282

• HRV • Heat Reclaim Ventilation
59
• HRV • VAM-FA8VE
1
7
7 Product Specification
7-2 Optional accessories
7-2-7 DCS302C51: Centralized control
SETTING OPERATION MODE
(Fig. 5)
• The Zone consists of the following two cases.
See page 121 if the display “ ” is flashing.
Press the OPERATION MODE SELECTOR BUTTON. Each
time you press this button, the display rotates as shown on
the right list.
NOTES:
• During cool/heat operation, this central remote controller
enables FAN operation for each zone even without setting the
master remote controller. Meanwhile, ventilation, ventilation/
cleaning, etc. are available, if HRV etc. are connected with this
unit in the zone. See the operation manual provided with the
each unit.
• When the indoor unit is in heat operation, change the setting to
FAN operation through the central remote controller; then, you
can switch the fan speed to the extremely low fan speed. Warm
air may blow if any other indoor unit belonging to the same
system is in heat operation.
• The indoor fan stops during defrost/hot start.
• DRY cannot be set from the central remote controller.
• List of setting operation
Note:
In the above list, “
{
” refers to the acceptable setting,
while “
×
” refers to the not acceptable setting.
In the meanwhile, 1 and 2 refer to the followings.
1: Setting may not be acceptable depending on the type
of indoor unit with which this unit is connected.
2: The group on FAN operation in the zone performs the
temperature control operation (cool/heat) under the outdoor
refrigerant system.
A. Zone without display “ ”
The group with master remote controller setting
exists in this zone.
Setting the master remote controller enables cool/
heat selection.
Operations other than cool/heat operations can also
be set for some operations. For further details, see the
list on the right.
B. Zone with display “ ”
No group with master remote controller setting exists
in this zone.
The cool/heat selection is not available because the
master remote controller has not been set.
Some operations other than cool/heat operations can
be set. For further details, see the list in the right.
1
(HC0163)
1
1
1
— —
A: Zones not displayed
Display Setting Contents of setting
To be set by zone
To be set by zone
To be set by zone
To be set by zone
To be set by zone
To be set by zone
Select this display if you don’t
wish to set by zone.
2
1
1
— —
B: Zones not displayed
Display Setting Contents of setting
To be set by zone
To be set by zone
Select this display if you don’t
wish to set by zone.