Daikin MCKB70YSAU, Руководство по установке и эксплуатации

Страница: 29 / 42

28
English
Maintenance
WARNING
Be sure to stop operation and unplug the power supply plug before performing maintenance.
(An electric shock or injury may result)
How to remove the humidifying tray and humidifying filter unit
1.
Remove the water tank. ►
Page 15
2.
Pull out the humidifying tray and remove
humidifying filter unit.
Humidifying
filter unit
Lift up slightly and pull out
Humidifying
tray
Hold the outer
periphery of the
frame
• If there is water inside, the water surface may shake
and spill, so pull it out slowly.
• Hold the bottom of the humidifying tray when carrying.
How to attach the humidifying tray and humidifying filter unit
1.
Attach the humidifying tray and humidifying
filter unit.
1 Attach the humidifying filter unit
Fit axle into groove in humidifying tray
Humidifying
filter unit
Groove
Axle
2
Push the humidifying tray all the way in
• If the humidifying filter unit is not properly attached to
the humidifying tray, the humidifying tray cannot be
attached to the unit.
Attention
After attaching the humidifying tray to the unit, do not forcibly
rotate the humidifying filter unit. Malfunction may result.
2.
Install the water tank. ►
Page 15
Humidifying tray
Wash with water
Wash with water about
1 time every 3 days, or if
odor and dirt are still an
issue.
• Use a soft cloth, brush, or
cotton swab to clean hard-
to-reach places.
• For areas with water scales,
remove the water scales
with a soft cloth or brush or
cotton swab soaked in
lukewarm or room
temperature water in which
citric acid has been
dissolved. (Lift up the float
and check that there are no water scales under the float)
Finally, rinse with water.
• Citric acid may be purchased at a pharmacy or drug
store.
Note
• Depending on water quality and the usage
environment, water in the humidifying tray may
become discolored due to water scales etc. Clean it
also in such cases.
• Make sure that the float is not stuck in water scales.
(Water leakage may result if the float is stuck)
Attention
Float
•
Do not remove.
Humidifying Operation
will become impossible.
If the float is detached from the tray
Insert the axle into the
hole of the tray
•
Make sure the float is
placed below the tray
protrusion.
Tray protrusion
Sectional illustration
Float
• Pour water into the tray and check that the float rises.
• After checking, be sure to discard the water, then
attach the humidifying tray to the unit.
Discard the residual water
in the tray from here
Float
01_EN_3P672685-2A.indd 28 2021/12/13 13:56:05