Daikin MCKB70YSAU, Руководство по установке и эксплуатации

Страница: 16 / 42

15
Read First
Preparation Before Operation
WARNING
Be sure to stop the operation and remove the power supply
plug before installation. (Electric shock or injury may result)
2.
Slowly pour water into the spout of the water
tank with a jug.
• Do not touch the lid of
the water tank when
fitting into the unit.
(Fingers may get
caught)
•
Do not touch the side
lock part when
pouring water.
(Water tank may fall)
• When supplying water
from above, clean the
water tank every day by
shaking a small amount
of water inside to
perform the Humidifying
Operation.
►
Page 27
• Do not pour water
other than the spout.
(Malfunction may result)
•
Do not pour water
beyond the full line
inside the spout.
(Water leakage may
result)
Full line
3.
Close the water tank
• Do not touch the side lock
part when closing.
(Fingers may get caught)
Press until a catching
sound is heard
When supplying water in the water tank
1.
Take out the water tank.
1 Securely hold the grip on the water tank and slowly
pull the tank toward you while pressing the lever.
Lever
Grip
2 Take out the water tank
by holding down the side
lock part on the water
tank with a finger to
unlock.
Side lock part
• When releasing the side lock part, be sure to support
the water tank with your hand.
2.
Fill the water tank with tap water.
• Perform in a place where
spilling water will not cause
a problem.
• Clean the water tank by
shaking a small amount of
water inside before filling up
the water tank with water.
For maintenance
procedures refer to
►
Page 27
[Viewed from below]
Avoid touching the
valve in the center.
(Water in the water
tank may leak)
• The water tank will weigh about 7.28lbs. (3.3kg)
when filled up to the full line.
Hold the water tank firmly with both hands when
carrying.
When carrying, fill to here
Full line
• Do not supply water beyond the full line of the water
tank.
(Water may spill when carrying the water tank or
installing it into the unit)
• Since the top surface is not sealed, water will spill if
the tank is tilted too much.
• If the water tank contains water, do not place it on
the floor or carpet. (The valve in the center may be
pushed and water may spill)
3.
Install the water tank.
• Hold the grip and install
the water tank in the
unit by fitting it into the
humidifying tray.
• Do not touch the side lock
part when installing.
(Fingers may get caught)
Water tank
1 Insert to match
this part
Humidifying tray
2 Press until a catching
sound is heard
5
Insert the power supply plug into the
power socket
• The basic sensitivity of the odor sensor will be determined
by odor levels in the first minute (approx.) after the power
supply plug is inserted.
Insert the power supply plug when the air is clean
(odor-free).
Power supply plug
Power socket
01_EN_3P672685-2A.indd 15 2021/12/13 13:55:56