Daikin MCKB70YSAU, Руководство по установке и эксплуатации

Страница: 19 / 42

18
English
Useful Functions
Humidifying and Air Purifying Operation
Fill the water tank with water.
►
Page 14, 15
1.
Press .
2.
Press to switch the humidity setting.
• Each press cycles between the humidity setting lamps (white).
(High) OFF (Low) (Standard)
• Pressing during operation will cause operation to stop.
After operation stops, humidifying filter drying operation will
start automatically.
Attention
• Make sure that the humidifying filter unit is attached
when performing this operation.
• Change the water in the humidifying tray and water
tank every day.
• Be sure to use tap water for the water in the water tank.
•
As leaving any residual water in the humidifying
tray will lead to bad odors and dirt build-up, be sure
to discard any residual water in the humidifying
tray once a day to perform Humidifying Operation.
• Perform during Humidifying Operation as well as
Air Purifying Operation.
(Humidification only operation cannot be performed.)
• Even if you have selected an airflow rate that suits
your preferences, if the water supply lamp lights
up, the airflow rate will change to “Quiet”.
If you do not want the airflow rate to change to
“Quiet”, change the setting.
►
Page 23, 24
(Depending on the degree of odor and dust, the
airflow rate may not change to “Quiet”.)
• When Humidifying Operation is started with the
airflow rate set to “Turbo”, “Turbo” airflow rate is
suppressed for about 10 minutes. After that, the
airflow rate changes to the set airflow rate, so the
operating sound also changes.
Low
Operation is carried out automatically with a humidity of
40% (*) as a rough estimate.
Standard
Operation is carried out automatically with a humidity of
50% (*) as a rough estimate.
High
Operation is carried out automatically with a humidity of
60% (*) as a rough estimate.
* Depending on the indoor and outdoor temperature and humidity, and
the room conditions, the target humidity may be exceeded (or not
reached).
►
Page 38
About Humidifying Filter Drying Operation
Setting at the time of purchase: “ON”
After stopping Humidifying and Air Purifying Operation using , perform Air Purifying Operation with the airflow rate reduced for
about 1 hour to dry the humidifying filters, shortening the period when the filters are left semi-damp and bacteria is likely to propagate.
• The humidifier lamp (white) slowly blinks.
• If Air Purifying Operation is performed for 1 hour or more after Humidifying and Air Purifying Operation, humidifying filter drying
operation will not be performed.
• If you do not want to perform humidifying filter drying operation, change the setting. ►
Page 23, 24
• If you want to stop humidifying filter drying operation while in progress, press .
• If you press , or during humidifying filter drying operation, humidifying filter drying operation will end
and the airflow rate and mode will be set according to the button pressed, or AUTO operation will be performed.
• When humidifying filter drying operation starts, UV rays stop being emitted. ►
Page 19
Note
• No steam (vapor) or fog can be seen.
• The room temperature may drop during Humidifying Operation.
• Splashing sounds may be heard during Humidifying Operation, but this is not a malfunction.
►
Page 35
• If the set humidity is reached or the water supply lamp lights up during Humidifying Operation, Humidifying Operation will stop,
but Air Purifying Operation will continue.
01_EN_3P672685-2A.indd 18 2021/12/13 13:55:57