SiBE12-816_D
RA Indoor Unit
Operation Manual
156
To start COMFORT AIRFLOW operation
5. Press “COMFORT AIRFLOW button”.
• The flap orientation will change, preventing air from blowing directly on the occupants of the
room.
• “
” is displayed on the LCD.
<COOL/DRY> The flap will go up.
<HEAT> The flap will go down.
To cancel COMFORT AIRFLOW operation
6. Press “COMFORT AIRFLOW button” again.
• The flaps will return to the memory position from before COMFORT AIRFLOW mode.
• “
” disappears from the LCD.
NOTE
• When “
SWING button
” is selected, the flap swinging
range depends on the operation mode. (See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates cold air, which
tends to collected at the bottom of the room, and hot air,
which tends to collect near the ceiling, throughout the room,
preventing areas of cold and hot developing.
Comfort Airflow
• The air flow is set automatically.
• The air direction is as shown in the figure at right.
ATTENTION
• Always use a remote controller to adjust the flap angle.
If you attempt to move it forcibly with hand when it is
swinging, the mechanism may be broken.
• Always use a remote controller to adjust the louvers angles.
In COOL or DRY mode
10°
40°
COOL/DRY
approx. 10°~40°
STOP
In HEAT or FAN mode
STOP
HEAT
approx. 30°~75°
FAN
approx. 5°~80°
30°
80°
75°
5°
In COMFORT AIRFLOW mode
STOP
HEAT
80°
COOL
5°
Содержание 2MKS40G2V1B
Страница 12: ...SiBE12 816_D 1 List of Functions Part 1 List of Functions 1 Functions 2 1 1 Cooling Only 2 1 2 Heat Pump 5 ...
Страница 180: ...SA Indoor Unit FFQ Series SiBE12 816_D 169 Operation Manual 2 Start 5s 5s 5s 5s 5s End ...
Страница 290: ...Outdoor Unit SiBE12 816_D 279 Removal Procedure 15 Lift and remove the electrical box Step Procedure Points R12537 ...