SiBE12-816_D
SA Indoor Unit - FFQ Series
Operation Manual
188
English
8
•
(2)
ON/OFF
Press ON/OFF button
NOTE
•
•
•
•
2
•
•
TEMPERATURE SETTING
In case of automatic operation
[
°
C]
•
The setting is impossible for fan operation.
NOTE
•
ADJUSTMENT
H M
• •
L
25
23
22
21
19
FAN OPERATION...................... “
”
DRY OPERATION..................... “
”
See “FOR SYSTEMS WITHOUT COOL/
HEAT CHANGEOVER REMOTE CONTROL
SWITCH” for details on dry operation.
Press OPERATION MODE SELECTOR
button several times and select “
”
(This operation is only available during
dry operation.)
OPERATION lamp lights up or goes off and
the system starts or stops OPERATION.
Do not turn OFF power immediately after
the unit stops. Then, wait no less than 5
minutes.
Water is leaking or there is something else
wrong with the unit.
[EXPLANATION OF HEATING
OPERATION]
DEFROST OPERATION
As the frost on the coil of an outdoor unit
increase, heating effect decreases and the
system goes into DEFROST
OPERATION.
The fan operation stops and the
DEFROST lamp of the indoor unit goes on.
After 6 to 8 minutes (maximum 10
minutes) of DEFROST OPERATION, the
system returns to HEATING OPERATION.
Heating capacity & Outdoor air
temperature
Heating capacity drops as outdoor air
temperature lowers. If feeling cold, use
another heater at the same time as this air
conditioner.
Hot air is circulated to warm the room. It
will take some time from when the air
conditioner is first started until the entire
room becomes warm. The internal fan
automatically turns at low speed until the
air conditioner reaches a certain
temperature on the inside. In this situation,
all you can do is wait.
If hot air accumulates on the ceiling and
feet are left feeling cold, it is recommended
to use a circulator. For details, contact the
place of purchase.
For programming TEMPERATURE, FAN
SPEED and AIR FLOW DIRECTION, follow
the procedure shown below.
Press TEMPERATURE SETTING
button and program the setting
temperature
Each time this button is pressed,
setting temperature rises 1
°
C.
Each time this button is pressed,
setting temperature lowers 1
°
C.
Each time this button is pressed,
setting temperature shifts to “H”
side.
Each time this button is pressed,
setting temperature shifts to “L”
side.
Setting
temperature
The setting temperature range of the
remote controller is 16˚C to 32˚C.
Содержание 2MKS40G2V1B
Страница 12: ...SiBE12 816_D 1 List of Functions Part 1 List of Functions 1 Functions 2 1 1 Cooling Only 2 1 2 Heat Pump 5 ...
Страница 180: ...SA Indoor Unit FFQ Series SiBE12 816_D 169 Operation Manual 2 Start 5s 5s 5s 5s 5s End ...
Страница 290: ...Outdoor Unit SiBE12 816_D 279 Removal Procedure 15 Lift and remove the electrical box Step Procedure Points R12537 ...