Curtiss-Wright R-NET, Техническое руководство

Страница: 98 / 206

Curtiss-Wright | PG Drives Technology
SK77981-14
98 | R-net Technical Manual | Chapter 3 – Programming
The programmable range for Low Voltage Time is 1s to 255s in steps of 1s.
11 GENERAL
11.1 BRAKE DISCONNECTED ALARM
This sets whether there is an audible alarm when one or both of the brakes are disconnected from the Power Module.
The programmable options are Yes and No.
11.2 BRAKE FAULT DETECT
This sets whether the Power Module will detect electrical faults in the wheelchair’s brakes or the connection to them.
The programmable options are Yes and No.
WARNING:
This parameter should only ever be set to No if there are no electrical brakes fitted to the wheelchair.
11.3 BRAKE VOLTAGE
This sets the voltage output from the Power Module to the wheelchair’s electrical brakes.
The programmable options are 12V and 24V.
WARNING:
It is essential the correct value for the brakes’ operating voltage is set. An incorrect value could result in damage to the
brakes or motors. Curtiss-Wright accepts no liability for losses of any kind resulting from incorrect programming of this
parameter.
11.4 SOFT STOP RATE
This sets the deceleration rate that is used while the wheelchair is “soft-stopping”. “Soft-stopping” is if the system is powered-
down while the wheelchair is being driven.
The programmable range is 0 to 200 in steps of 1.
If this value is the same or lower than the Forward Deceleration value, then the latter value will be used for “soft-stopping”.
WARNING:
It is the wheelchair manufacturer’s responsibility to ensure that the wheelchair complies with the correct legislation for
braking distances for the country in which the wheelchair is to be sold. Curtiss-Wright accepts no liability for losses of any
kind resulting from incorrect programming of this parameter.
11.5 SEAT REVERSAL