Curtiss-Wright R-NET, Техническое руководство

Страница: 203 / 206

SK77981-14
203 | R-net Technical Manual | Chapter 11 – Warning Summary
Curtiss-Wright | PG Drives Technology
2.38 BATTERY GAUGE
WARNING:
Do not operate the control system if the battery is nearly discharged. Failure to comply with this condition may leave the
user stranded in an unsafe position, such as in the middle of a road. Curtiss-Wright accepts no liability for losses of any kind
arising from failure to comply with this condition. Chapter 4 Section 2.1.1.
2.39 GETTING READY TO DRIVE
WARNING:
If you push the joystick before or just after you switch the control system on, the battery gauge will ripple up and down. Yo u
must release and center the joystick to resume normal operation. If you do not release the joystick within five second s the
wheelchair will not be able to move, even if you release the joystick and push it again. The battery gauge will flash 7 LEDs at
this time. You can reset this condition by switching the control system off and on again. Refer to section 3. Chapter 4 se ction
4.
2.40 GENERAL
WARNING:
The chair manufacturer is responsible for establishing the suitability of the particular wiring arrangements used on the
wheelchair, for both normal use and stalled conditions. Curtiss-Wright can make general recommendations for wiring for R-
net control systems, but Curtiss-Wright accepts no responsibility for, and accepts no liability for losses of any kind arising
from, the actual wiring arrangement used.
The chair manufacturer is responsible for ensuring that only the mating connectors specified by Curtiss-Wright on the control
systems specific data sheet are used to connect to the control system. Curtiss-Wright accepts no liability for losses of any
kind arising from failure to comply with this condition.
The chair manufacturer is responsible for ensuring that suitable connectors are used and securely mated throughout the
chair wiring system and that the workmanship associated with the wiring system is of a good enough quality. Failure to meet
this condition could result in intermittent operation, sudden stopping or veering, or even create a burn or fire hazard.
Curtiss-Wright accepts no liability for losses of any kind arising from failure to comply with this condition. Chapter 4 section
6.
2.41 INTRODUCTION
WARNING:
Diagnostics should only be conducted by healthcare professionals with in-depth knowledge of Curtiss-Wright electronic
control systems. An incorrect or badly effected repair could result in an unsafe set -up of a wheelchair. Curtiss-Wright accept
no liability for losses of any kind arising from an incorrect or badly effected repair. Chapter 5 Section 1.
2.42 PM MEMORY ERROR
WARNING:
Programming should only be conducted by healthcare professionals with in-depth knowledge of Curtiss-Wright control
systems. Incorrect programming could result in an unsafe set-up of a wheelchair for a user. Curtiss-Wright accept no