Curtiss-Wright R-NET, Техническое руководство

Страница: 199 / 206

SK77981-14
199 | R-net Technical Manual | Chapter 11 – Warning Summary
Curtiss-Wright | PG Drives Technology
charger plugs. This presents a potential burn hazard for the user. Curtiss-Wright accepts no liability for losses of any kind
arising from failure to comply with this condition.
Ensure that the charger plug pins are of the correct polarity to be compatible with the pin polarity shown on the control
system’s specific data sheet. Failure to observe this condition could result in a burn hazard or fire hazard. Curtiss-Wright
accepts no liability for losses of any kind arising from failure to comply with this condition.
Do not disconnect batteries or open-circuit the circuit breaker while charging is in progress. Failure to observe this condition
could result in a burns hazard or fire hazard. Curtiss-Wright accepts no liability for losses of any kind arising from failure to
comply with this condition.
Examine all electrical appliances intended for use with the wheelchair, including the battery charger, regularly for damage,
especially the cord, plug and enclosure. If the appliance is damaged, it must not be used until it has been repaired. Curtiss-
Wright accepts no liability for losses of any kind arising from failure to comply with this condition. Chapter 2 Section 7.1.
2.17 DRIVE MOTORS
WARNING:
The chair manufacturer is responsible for ensuring that the control system is matched to the motor resistance. Failure to do
this may result in poor control characteristics, which in extreme instances can make a chair uncontrollable and potentially
unsafe. Curtiss-Wright accepts no liability for losses of any kind arising from failure to comply with this condition.
The chair manufacturer is responsible for always ensuring that any replacement motors or gearboxes are fully compatible
with the originals that the control system was designed to match. Failure to do this may result in poor control characteristics,
which in extreme instances can make a chair uncontrollable and potentially unsafe. Curtiss-Wright accepts no liability for
losses of any kind arising from failure to comply with this condition.
Users must not move a control system from one chair type to install it on a different chair type. Control systems with
different part numbers may have both hardware and software differences to ensure that they are compatible with the
electrical and dynamic characteristics of their specific target vehicles. The characteristics of one type of control system m ay
not be the compatible with a different, unauthorized chair. Failure to observe this warning could result in an unsafe setup for
the wheelchair user and may create a fire hazard depending on the motors, wiring, connectors and circuit breakers installed
on the unauthorized chair. Curtiss-Wright accepts no liability for losses of any kind arising from failure to comply with this
condition. Chapter 2 section 8.
2.18 SOLENOID BRAKES
WARNING:
It is essential that the control system is programmed for the correct brake voltage. If it is not, damage may occur to the
brakes or the drive performance of the wheelchair may be affected. Chapter 2 section 9.
2.19 INTRODUCTION
WARNING:
Programming should only be conducted by healthcare professionals with in-depth knowledge of Curtiss-Wright control
systems. Incorrect programming could result in an unsafe set-up of a wheelchair for a user. Curtiss-Wright accept no
responsibility for losses of any kind if the programming of the control system is altered from the factory pre -set values.
Chapter 3 Section 1.