Aerial work platform
B-LIFT 18 HV
3
COD. UM0287_GB | REV. 0.0 | ED: 09/18
Chapter 6
GB
PROCEDURES FOR USE
6.3
Operating stages
6.3.1
Pre-start checks
CAUTION
You must have read and understood the operation and maintenance manual
before using the machine.
Only use the elevating work platform (MEWP) for the uses intended by the
manufacturer and speciied in this manual.
The lifting platform can only be used with braked and stabilised vehicle on a
level and solid surface.
Before starting to use the lifting platform, it is recommended that you carry out a series of checks,
both on the machine and in the area in which the machine will be positioned.
•
check that the ground is compact and able to support the weight of the machine (the load for
each stabiliser is speciied in the technical speciications and on the stabiliser itself).
•
check that the ground is level or that it has an inclination of no greater than 3°.
•
inspect the work area (see subsection 2.6.2)
•
check for the presence of obstacles and overhead lines in the work area that could obstruct or
limit the use of the machine.
•
check that there is a suficient amount of fuel in the vehicle’s fuel tank.
•
check that the operation and maintenance manual is present and that it is complete and legible.
•
check that all adhesive labels are present and legible (see Section 3.5).
•
check the level of hydraulic oil and top up if necessary (see chapter 8 “Maintenance”).
•
inspect the aerial work platform, checking the following components and areas for any damage,
missing or improperly installed parts or oil leaks:
»
electrical components, cables and electrical wires
»
hydraulic hoses/pipes, ittings, cylinders and distributors
»
slewing ring motor
»
nuts, bolts and other fastening components
»
structural or welding cracks and damage to the machine
»
work platform and access gate
»
limit switches and safety devices
•
check that the deviator valves used to reset the levelling of the platform are in the extension
position and that the padlock is closed.
•
check that the controls in the platform are working properly before lifting it to a height.
•
check that the working area is cordoned off, marked with signs and free of obstacles
•
check that the safety systems are working properly (see chapter 5)
CAUTION
If one or more safety systems are damaged or faulty, DO NOT USE THE
PLATFORM!
Report the fault immediately to the nearest authorised service centre
•
check that the batteries are in good working order
•
check that connections to external supplies have been carried out properly
•
check that the route the work platform has to follow to reach the working point is free from
obstacles
6.3.2
Starting the vehicle
Procedure:
•
Sit in the driver’s seat.
•
Make sure the vehicle won’t move by pulling the handbrake and place the gear lever in neutral.
