2
Aerial work platform
B-LIFT 18 HV
COD. UM0287_GB | REV. 00 | ED: 09/18
GB
Chapter 15
OPTIONAL EQUIPMENT AND ACCESSORIES
Fig.
15.1
Accessory only available for machines itted with a 230V electrical socket on the work
platform. The images of optional equipment are indicative only.
15.4
Auxiliary electric motor
The platform can be equipped with an auxiliary electric motor
M2
. The platform can be powered either
by the engine of the vehicle or by the auxiliary electric motor.
The controls are located on the bed of the vehicle (see section 4 Controls), on the opposite side to the
stabilizer controls, and allow the platform to be used without having to enable the system from the cab.
The electric motor, which is independent from the vehicle on which it is installed, must be connected
to an external power supply (220V), via the socket (7).
It can be used under any conditions. It is especially recommended to be used in the case of:
•
A vehicle engine breakdown
•
A fault in the hydraulic motor connected to the vehicle engine
•
Work to be undertaken in closed places (tunnels, warehouses etc.), to prevent exhaust gas
being emitted to the environment.
If possible, place the vehicle next to the point you have to reach and prepare the work platform for use.
•
Switch off the engine of the vehicle
•
Put the gear lever in neutral.
•
Pull the parking brake.
•
Connect the electric motor to an external 220V electricity supply via the socket (7)
•
If the indicator light (5) is not on, press the reset button (2)
•
Start the electric motor
The speed is controlled automatically.
