Crown Boiler PHNTM399, Инструкция по установке и эксплуатации

Страница: 102 / 120

102
XI. Service and Maintenance
(continued)
Outdoor Temperature
Ohms of
Resistance
°F °C
-20 -28.9 106926
-10 -23.3 80485
0 -17.8 61246
10 -12.2 47092
20 -6.7 36519
30 -1.1 28558
40 4.4 22537
50 10.0 17926
60 15.6 14356
70 21.1 11578
76 24.4 10210
78 25.6 9795
80 26.7 9398
90 32.2 7672
100 37.8 6301
110 43.3 5203
120 48.9 4317
Outdoor Air Temperature Sensor
Temperature versus Resistance
(P/N 350082)
(10kOhm NTC Sensor)
Temperature Ohms of
Resistance
°F °C
32 0 36100
50 10 22790
68 20 14770
77 25 12000
86 30 9810
104 40 6653
122 50 4610
140 60 3250
158 70 2340
176 80 1710
194 90 1270
212 100 950
230 110 730
248 120 560
Supply, Return and Stack Temperature Sensor
Temperature versus Resistance
(12kOhm NTC Sensor), Beta of 3750
Header Temperature Sensor
Temperature versus Resistance
(P/N 32003971-003)
(10kOhm NTC Sensor), Beta of 3950
Temperature Ohms of
Resistance
°F °C
32 0 32648
50 10 19898
68 20 12492
77 25 10000
86 30 8057
104 40 5327
122 50 3602
140 60 2488
158 70 1752
176 80 1256
194 90 916
212 100 697
248 120 386
2. Condensate Trap Removal and Reinstallation:
a. Disconnect power supply to boiler.
b. Remove 2 wire nuts and disconnect overflow switch
wire pigtails from boiler wiring.
c. Disconnect pressure switch hose from condensate
trap.
d. Disconnect outside condensate compression fitting
from condensate trap.
e. Using pliers, release spring clip securing the
overflow switch to condensate trap body and remove
the switch. Note that the switch has factory applied
silicon adhesive seal, which may have to be carefully
cut all around to facilitate the switch removal.
f. Using pliers, release spring clip securing condensate
trap body to the heat exchanger bottom drain
connection.
g. First, pull the trap downwards to release from the
heat exchanger. Second, pull the trap end from left
side jacket panel sealing grommet and remove the
trap from boiler.
h. To reinstall the trap, reverse above steps.
i. If the original condensate overflow switch is to
be re-used, follow the appropriate switch removal
steps from Condensate Overflow Switch Removal
and Replacement procedure above.
j. Insure that fresh silicon sealant is applied to the
overflow switch threads and the switch is properly
oriented relative to the trap body - the arrow molded
into the switch hex side end must face down for
proper switch operation. See Figure 44 “Condensate
Overflow Switch Orientation” for details.
k. Insure that pressure switch hose is reconnected to
the trap.
l. Restore power supply to boiler. Fill up the trap
(see Section V “Condensate Disposal”) and
verify the switch operation.