HT-OMSMART-A
26
SECTION 4
PRODUCT FEATURES / FAMILIARISATION
Attach and adjust all Jockey stands before detaching
linkage arms.
Ensure all caps for the electrical (looms) and hydraulic
fittings are utilised to help prevent water, dust & dirt ingress.
Photo is for a conventional sprayer without linkage arm
connections.
Wheel Speed Sensor
All sprayers are fitted with a Speed Sensor – normally via
a proximity sensor installed on the right hand side, rear
wheel. The sensor needs to be 5mm from the target, which
in this case is the head of the wheel studs on the back of
the axle. The sensor is reading cm per pulse.
A GPS speed sensor (Atlas 100) is available as an option.
Pump Speed sensor (photo 2)
The same sensor is used for the spray pump speed.
The reading is 1 pulse per revolution.
Flow Meter (photo 3)
All Smart Sprayers are fitted with a flow meter. As a part
of the initial factory testing / calibration, a value (pulses
per litre) will have been recorded and written on the body
of the meter (shown here in blue) or the back of the serial
number tag.
Photo 2
Photo 3
