Corghi Artiglio 500, Руководство оператора

Страница: 63 / 265

Operator’s manual Artiglio 500 63
GB
Recommendations
To ensure the perfect condition of the rims, we recommend to replace the plastic inserts
beneath the head (fig.36A-B) every 2 months, or sooner in case of excessive wear and
tear. The inserts for the replacement are supplied with the machine.
Information
Any noise heard when the tool head engages with the tyre is normal. The noise is made
by the mechanical return of the tool and not because the tool has hit the rim. Even if the
tool does touch the rim as the tyre is engaged, this will not damage the rim in any way.
The pressure applied is very low.
If you wish to prevent this noise, simply press the bead breaker disc harder against the
bead when picking it up.
WARNING
Bead breaking is well known to be a dangerous operation. It must be carried out in
accordance with the instructions below.
Car, off-road vehicle and van wheels
GUIDE TO CORRECT USE
WARNING
Read the “PRACTICAL HINTS, RECOMMENDATIONS AND USEFUL INFORMATION”
section above with great care.
DEMOUNTING
1 • Loading the wheel (fig.9a)
- Place the wheel on the lift (A).
- Lift the wheel by operating the pedal 1 (B).
- Transfer the wheel to the turntable (C) by hand and lower the lift by operating the pedal
2.
- When positioning the wheel on the turntable, also take care to align the mobile pin, on
the edge of the turntable, in one of the fixing bolt holes in the rim (D).
2 • Clamping the wheel on the turntable (fig.10)
- Fit the clamping device into the drop centre of the wheel (A).
- Turn the device for correct engagement with the turntable (B).
- By hand, move the centring cone into pos. on the rim by moving the retainers 1 (C).
- Tighten the clamping device by turning the handles 2 clockwise (D).
3 • Deflating the tyre (fig.11)
- Undo the valve and fully deflate the tyre.
4 • Upper bead-breaker positioning (fig. 12)
- Lower the upper bead-breaker unit from idle position to operating position by means
of the lever 12-2